POCKET CAP FRONT

PCF
AUD$127.60

 

The Pocket Cap Front mimics the front panel of the Front Bag.It zips onto the front side of any module except the Front Bag.

It comes with a portfolio handle.


 

addthis

 

The Pocket Cap Front mimics the front of the Front Bag. It is 13.5" x 10.5" x 1.25". ThePocket Cap Frontattaches to the CS2, CS3, CS4, CS5, and CS11.

There are nine pockets on the outer surface of the Pocket Cap Front. You can plainly see three different pocket locations. Each of these three pockets pocket compartments actually contain three pockets: [1] A main pocket area. This Main pocket area is designed to hold your mobile device, wallet and keys. [2] A small secondary pocket tucked in the top of each pocket. This pocket is designed to hold a flashlight and fuel tester. [3] And then a small flat pocket on the front cover of each pocket. This is designed to hold your electronic E6B, camera, business cards, iPod. These pockets are great for organizing all the little stuff in your personal and professional life.

The Pocket Cap Front is not designed to be used alone because the separation zipper would be exposed and could be damaged. Always zip the Pocket Cap Front onto one of the other FLEX System modules.

A great FLEX System option that works really well is to zip this Pocket Cap Front onto a Rear End Cap. This forms a configuration called B0 SLIM. This gives you a nice thin bag that is perfect for carrying your iPad, some documents, cords, cables, etc. It also turns out that the 13" Mac Book Air, and even the 13" Mac Book Pro will fit between these two End Caps. To carry the B0 SLIM, you'll make use the included Slim Handle which attach to the bag with the two small rectangular clips. These clips have a gap in them which allows you to thread them into the two small loops on the side of the Pocket Cap Front. (There are two more loops on the top of the bag as an option.) DO NOT CARRY ANY BAG BIGGER THAN THE PORTFOLIO WITH THE PORTFOLIO HANDLE. Alway use the Main Handle when the Front End Cap is attached to any of the main modules.

NOTE: The FLEX modules WILL NOT WORK with (will not zip onto) any older BrightLine Bag. The zippers had to be of a different type to allow this modularity concept to work. The Pocket Cap Front can attach to all of the front panels of the FLEX System modules (so this excludes the Front Bag since the Front Bag doesn't have an available front surface.)

NOTE ALSO: The Pocket Cap Front is one-directional (as are ALL of the FLEX System modules). It is always front-facing. That means that it can only be zipped onto the FRONT SURFACE of any module. You cannot zip a Pocket Cap Front onto both the front and the rear of a center section. You must use a Rear Bag or a Rear End Cap on the REAR SURFACE of any module.


 

No recommended products at the moment.