GA Pitot Tube Cover

psgaptc0707
AUD$29.55
Stock 0

The GA Pitot Tube cover works on most Cessna, Piper, Beechcraft and other angled pitot tubes.

addthis

Our GA Pitot Tube cover works on most Cessna, Piper, Beechcraft and other angled pitot tubes. Unlike the standard angled pitot tube covers, we use nylon thread to sew on, not glue our large pieces of Velcro so that our hook/loop pieces never come off, as is so common with our competition.

From tip to back the tube must not exceed 6.75”. If it does, our Universal Pitot tube cover would be a better choice. Reflective is 7.75” long. Inside diameter of the cover is 7/8’s of an inch.

Each year, over 18 percent of small aircraft suffer ground damage to win-tips, static wicks, elevators, rudders, rotors, propeller blades and other parts while being moved in and out of crowded community hangars.
 
•   highly reflective markers make vulnerable areas clearly visible under all conditions, and their projecting "proximity fuses" warn that something is too close before damage occurs.
•   markers are easily custom-fitted to virtually any aircraft, take only minutes to attach and remove, and weigh only three pounds folded into their briefcase-size pouch.
•   markers are available in sets of two to five pieces, for fitting to win tips and propeller blades. A full set, including its carrying pouch, weighs only three pounds and stows under any aircraft seat. Once initial fitting is done, the markers can be installed and removed in minutes during routine pre- and post-flight walk-arounds.
 

No recommended products at the moment.